PRÜFTECHNIK VIBXPERT II - Setting Up the Network Communication

2-34
VIBXPERT II 05.2012
Getting started - Data transfer
Left:
Open menu for
network communication
Right:
TCP/IP settings for
network communication
Setting up the network communication
• ConnectVIBXPERTtothenetwork(seepreviouspage).
• SwitchonVIBXPERT.
• Clickon'DeviceSetup'inthestartscreen,andthenon'Ethernet':
• EnteravalidIPaddressforVIBXPERT:
Take the first three numbers of your PC's IP address and change
the last number only (see also the following instructions). Make
sure that the IP address for VIBXPERT is not already allocated in
the network. Contact your system administrator if you work in a
company network.
• In the 'Subnetmask' eld, enter the address of the subnetwork
where the PC is located.
• Ifnecessary,entertheaddressofthegatewayinthe'Standardgate-
way' field. If no gateway is used, set the field to '0.0.0.0'.
• Toacceptthesettings,pressMENUandclickon'OK'.