PRÜFTECHNIK VIBXPERT II - Start Measurement

3-15
VIBXPERT II 05.2012
Start measurement
• Clickon'Machinetemplate'inthestartscreen.
A list of the available machine templates appears (see below).
Machines where measurements have already been carried out ap-
pear subordinate to the associated template. The number of the
measured measurement location and the total number of measure-
ment locations is indicated in the right column ('Finished') for each
machine.
The info field for the highlighted machine at the bottom shows
when the corresponding template was loaded into the data collec-
tor and when the last measurement was carried out.
To continue the measurement on a machine, click on the corre-
sponding subordinate machine.
• Clickonthetemplatethatyouwanttouseforthemeasurement.
The ‘Machine description’ dialog appears where a name for the
new machine is specified.
• If you do not want to enter any further information, press the
MENU key and click on ‘OK’ to accept the name.
• OtherwisepresstheMENUkey,clickon‘Details’(seebelow)and,
if necessary, enter the necessary data as follows:
- Position the cursor in the corresponding text field and press 'Enter'
to open the text editor.
- After entering the data, press the MENU key and click on OK.
You can change the machine description at any time.
Left:
Enter machine details
Right:
Machine template list
Template
Machine
Measurement - Machine template

Note
Info field