PRÜFTECHNIK VIBXPERT II - Memory Card; Replacing the Memory Card

2-10
VIBXPERT II 05.2012
Memory card
ACompactFlash (CF) card with 2 GB memory capacityisinstalled
in the VIBXPERT as standard. If required, the standard card can be
replaced by a card with greater memory capacity.
Backup all data before replacing the card using the 'VIBXPERT util-
ity'program(seepage6-8)!
When closing the cover, it must be additionally sealed with a sili-
coneadhesive(NOVASILS11)toensurethedustseal(IP65).
Replacing the memory card
• SwitchoffVIBXPERT.
• Carefullyremovethecoverinthegrip.Makesurethattheclipof
the cover is not damaged.
• Pulloutthememorycardbytheadhesivestrip.
Getting started - Memory card
• Installation:
Insert the new card in the guide rails of the card slot. Carefully
press in the card up to the endstop. Make sure the card is correctly
oriented! The top of the card should face the back of the device.
Compartment for memory card open
Attention!
Carefully pull out the memory
card by the adhesive strip