PRÜFTECHNIK VIBXPERT II - Entering the Normalization Parameters

5-3
VIBXPERT II 05.2012
Entering the normalization parameters
Before the shock pulse measurement starts, the normalization screen
appears:
• Selectthetypeofnormalization:
no normaliZation:ShockpulsevaluespeciedindBsv.
manual: RPM is entered manually before the shock pulse measure-
ment.
external: RPM is measured with an RPM sensor before the shock
pulse measurement.
• EnterthedBavalueifitisknown.Otherwise,carryoutanormal-
ization adaptation (set dBa to '0', see previous section).
• Enterthediameterofthebearinginnerrace.
• Ifthenormalizationtypeissetto'manual',entertheRPM(seebe-
low).
• Tostarttheshockpulsemeasurement,clickon'OK'.
Shock pulse - Normalization
Measurement tasks