PRÜFTECHNIK VIBXPERT II - Page 58

3-8
VIBXPERT II 05.2012
Measurement - Route
Notes about the tree view:
-Ifthe'GraphicRoute'optionisactivated(p.2-14),youcanselect
the measurement location using the machine graphic (see left).
- If the branch cannot be opened up to the measurement location
level, press the MENU key and select 'Expand' -> 'Meas. points'
(see below).
Notes about the list view:
- The list view only shows the measurement locations.
- The order of the measurement locations in the list view can vary
from the order in the tree view. The list view indicates the order
of the route. The tree view indicates the sequence in the measure-
ment location database.
Standardsensorisactivewhenthesensoriconatthetopleftisor-
ange and the sensor type in the info field is marked red! The sensor
setupisoverwrittenwiththestandardsensor.(p.3-3).
Reference measurements must be carried out first (e.g. RPM mea-
surement for the normalization of a bearing measurement).
Various route options shorten the measurement times. Depending
onwhichoptionisenabledintheRouteSetup,themeasurements
cantakeplacevirtuallyautomatically(seealsop.2-16).

Note
Left:
Measurement tasks in the route
Right:
Route in tree view / list view
Measurement channel and sensor
Centrifugal pump Motor
Aggregates und machines in the tree
view (left) and in the machine graphic
view mode (right).
Reverse path to meas. location

Note
Attention!