PRÜFTECHNIK VIBXPERT II - Runtime Setup - Route:

3-11
VIBXPERT II 05.2012
Measurement - Route
info
The following information is displayed for the highlighted element
- Path in the OMNITREND database
 -Hierarchytype(e.g.train)
- ID (identification number in the database)
 -Sequencenumber=orderoftheelementsintheroutelistview
- Task statistics (measured, skipped, not measured)
 -VIBCODEcodenumberandcoderingpattern(‘ShowVIBCODE’).
list (tree)
 Toggleroutedisplaymode:Listview/Treeview.
*expand / (hierarchy)
If the hierarchies are not all displayed in the tree view, they can be
displayed with this function.
*find > criteria
 Searchfunction;Theroutecanbesearchedaccordingtonameor
ID number of an element. Enter the search item in the text editor.
*pool / route
Display optional measurement tasks to be measured as required /
switch over to route mode.
multimode > start / results
Change to ‘Multimode’ mode to perform measurements which are
not programmed in the route. After the measurement, press the
ESCkeytoreturntoroutemode.The'Multimode'resultsareau-
tomatically allocated to the element in the route from which the
operating mode was changed.
To display the results, select
multimode > results and click on the
saved measurement result.
*device setup - route:
Change the basic settings for route mode. The changes then also
applyforallothersubsequentroutemeasurements(seepage2-14,
‘Basic settings’).
*device setup - display:
 Changethedisplaysettings(seepage2-13,‘Basicsettings’).
runtime setup - route:
Change the following parameters for the active route:
 -Standardsensorforvibrationmeasurement;achangeisonlypos-
siblewhenthisoptionisdisabledintheDeviceSetup.
 -Measurementchannel=A,BorAuto;mustbesetto‘Auto’for
‘Near locations’ and triaxial sensors.
- RPM entry: Manual entry of the RPM value (yes/no).
print
Print out measurement tasks and results (characteristic values
only)(seep.4-24).
* The 'Menu' function is only available
in the Tree view