PRÜFTECHNIK VIBXPERT II - Disabling the Spatial Sequence: ‘Near Location’ Can Be Disabled in the Route:

3-33
VIBXPERT II 05.2012
Near location
Restrictions
- The grouping of measurement tasks to a 1+1 measurement is only
possibleifrmwaremodule‘2channels’(VIB5.381)hasbeenreg-
istered in the device.
- For ‘Near locations’, the "Multitask" measurement task is disabled.
- In the route runtime setup, a standard sensor should not be set up
andthemeasurementchannelmustbesetto'Auto'(p.3-18).
- Because a trend display is not possible for 1+1 measurements, the
last measured result always appears when a result is loaded via the
measurement task selection.
Options during the route
Skipping a measurement location/measurement task (see p. 3-10):
- If you skip over a measurement task, only the grouped measure-
ment task within the 1+1 measurement is skipped.
- If you skip a measurement location, the near location is skipped as
well - including all associated measurement tasks.
Disabling the spatial sequence:
‘Near location’ can be disabled in the route:
This procedure affects the selected route element and the appropri-
ate tasks. This procedure cannot be reversed!
• Inthetree/listview,selectarouteelementandpresstheMENU
key.
• Clickon‘Breaknearlocation’(seebelow).
All lower level measurement tasks are then performed like nor-
mally configured one-channel measurements.
Attention!
Disabling near location(s)