Quantum Scalar i40 User Manual

Chapter 4: Configuring the Library
Working With Local User Accounts and Passwords
Quantum Scalar i40 and Scalar i80 User’s Guide 87
Disabling Passwords on
the Operator Panel
If you no longer want to use passwords on the operator panel, you can
disable them. Once you disable the admin password, the user password
is also automatically disabled. You can only do this on the operator
panel.
Operator Panel
1 Select Setup > Account Settings > Password Settings.
Admin Password is highlighted.
2 Press Modify to modify the Admin password.
Enabled is now highlighted.
3 Press the Down button to change the setting to Disabled.
4 Press Apply.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
Modifying Passwords
on the Operator Panel
Once passwords are created, you can modify them.
Operator Panel
1 Select Setup > Account Settings > Modify Password.
2 Use the Up and Down buttons to select admin or user.
3 Press Apply.
4 Enter the current password and press Apply.
5 Enter a new password and press Apply.
6 Re-enter the new password to validate it and press Apply.
7 Save the library configuration (see Saving the Library Configuration
on page 107).

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g