Chapter 9: Installing, Removing, and Replacing Components
Removing and Installing a Filler Plate
270 Quantum Scalar i40 and Scalar i80 User’s Guide
3 Lift the filler plate up to disengage the catch at the bottom and pull
the filler plate out of the slot.
Installing a power supply filler plate:
• On the Scalar i80, if you are using only one power supply, you
should install the power supply in the upper slot, and cover the
lower slot with a filler plate (see Figure
64 on page 270).
1 Hold the filler
plate with the thumbscrews at the top.
2 In
sert the bottom edge of the filler plate into the slot, engaging the
bottom edge of the filler plate into the bottom of the slot.
3 Pivot the filler
plate up to fit securely in the hole.
4 Tighten the thumbscrews.
Figure 64 Filler Plates Installed
To Next Page
Loading...
