Quantum Scalar i40 User Manual

Chapter 8: Getting Information About the Library
Viewing Library Information
206 Quantum Scalar i40 and Scalar i80 User’s Guide
Viewing Library Information
The About screen gives you a quick glance at the following library
settings:
• Library type (Scalar i40 or Scalar i80)
• Library serial number
• Copyright date
• Library firmware version
Web Client
Select Reports > About > Scalar i40/i80.
Viewing System Information
The System Information report contains information about the library.
On the operator panel, the report provides:
• Physical library information — serial number, system control board
(SCB) revision, firmware version, board support package (BSP)
version, date and time of last firmware update
• Tape drives — online/offline mode, firmware version, model,
physical serial number, logical serial number
• Robot firmware versions — XY control, picker, camera
On the Web client, the report provides:
• Date & Time — Current date, time, and time zone settings.
• Physical Library — Host name, IPv4 address, serial number, firmware
version of the physical library, IPv6 addresses if IPv6 support is
enabled, board support package (BSP) level, and the date the
firmware was last updated.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g