Quantum Scalar i40 - Figure 31 Configuring Encryption Settings and Key Server Addresses

Chapter 7: Encryption Key Management
Configuring Scalar Key Manager (SKM) on the Library
178 Quantum Scalar i40 and Scalar i80 User’s Guide
Figure 31 Configuring
Encryption Settings and Key
Server Addresses
3 Automatic EKM Path Diagnostics: Enable or disable this feature
and set the test interval as desired. For more information, see
Enabling Automatic EKM Path Diagnostics on page 184).
4 Secure Sockets Layer (SSL): SSL is a
lways enabled. The SSL port
number is always 6000.
Note: While the setting is called SSL, the library actually uses
Transport Layer Security (TLS), a more secure successor to
SSL, to communicate with the encryption servers.
5 In the Primary Key Server IP Address or Host text box, enter either:
• The IP address of the primary key server (i
f DNS is not enabled),
or
• The host name of the primary key server (if DNS is enabled).
6
Port Number: The port number is always 6000. You cannot change
SKM port numbers.
7 Ente
r the IP address or host name of the secondary key server into
the
Secondary Key Server IP Address or Host text box.
8 Click
Apply.