Quantum Scalar i40 User Manual

Chapter 4: Configuring the Library
Configuring Security Settings
Quantum Scalar i40 and Scalar i80 User’s Guide 105
Remote Access Via Web
Client
Enables or disables remote access to the library via the Web client. This
setting is enabled by default (meaning remote access is allowed).
Operator Panel
1 Select Setup > Security Services > Web client.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
Remote Service Login Enables or disables remote service user login (from the Web client or
over the Ethernet service port). The service user will still be able to log in
to the library from the operator panel. This setting is enabled by default
(meaning remote service login is allowed).
Operator Panel
1 Select Setup > Security Services > Service User
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
SNMP V1/V2 This topic is discussed in Enabling SNMP Versions on page 46.

Quantum Scalar i40 Specifications

General

Power requirements	100 - 240 V AC, 50 - 60 Hz, 2.8/1.4 Amps
Power consumption (typical)	100 W
Expansion slots	25
Dimensions (WxDxH)	455 x 793 x 132 mm
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Product type	Storage auto loader & library
Product color	Black

Weight and Dimensions

Weight	15800 g