Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
Quantum Scalar i40 and Scalar i80 User’s Guide 275
Figure 67 Removing/Installing
the Magazine Bezel
7 Remove the tape cartridges from the removed magazine and
carefully install them in the exact same slots in the replacement
magazine. Use the map you created if necessary.
8 Slide
the magazine into the magazine slot all the way until it stops.
The library performs an inventory
on the replaced magazine.
9 W
ait for the library to finish its inventory.
10 Run the
magazine diagnostics test on the replaced magazine to be
sure it is functioning correctly.
a Place a
scratch tape in the top I/E station slot.
b If
manual cartridge assignment is enabled, assign the scratch
tape to the System partition.
To Next Page
Loading...
