R&S FPC Series - Page 241

Remote Control
R&S
®
FPC
238User Manual 1178.4130.02 ─ 07
CALCulate<n>:MARKer<m>:FUNCtion:CPOWer:UNIT <Unit>
This command selects the unit of the for channel power measurements.
Prerequisites for this command
●
Select the channel power measurement (CALCulate<n>:MARKer<m>:
FUNCtion:POWer:SELect).
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<Unit> DBM | DBMV | DBUV | VOLT | WATT | V | W
*RST: DBM
Example: //Select the unit for the channel power
CALC:MARK:FUNC:CPOW:UNIT DBM
Manual operation: See "Power Unit" on page 362
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult:PHZ <State>
This command turns the display of the channel power in a 1 Hz bandwidth on and off.
Prerequisites for this command
●
Select the channel power measurement (CALCulate<n>:MARKer<m>:
FUNCtion:POWer:SELect).
Suffix:
<n>, <m>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Display the measured channel power in a 1 Hz bandwidth
CALC:MARK:FUNC:POW:RES:PHZ ON
Manual operation: See "Power Display" on page 362
19.12.1.3 Third Order Intermodulation
The following remote commands are exclusive to the occupied bandwidth measure-
ment.
CALCulate<n>:MARKer<m>:FUNCtion:TOI:RESult?......................................................... 238
CALCulate<n>:MARKer<m>:FUNCtion:TOI:SEARchsignal................................................ 239
CALCulate<n>:MARKer<n>:FUNCtion:TOI[:STATe]........................................................... 239
CALCulate<n>:MARKer<m>:FUNCtion:TOI:RESult?
This command queries the result of the third order intermodulation measurement.
Remote Commands of the Spectrum Application