R&S FPC Series - Page 369

Function Reference
R&S
®
FPC
366User Manual 1178.4130.02 ─ 07
20.4.8 Measurement Menu: AM Modulation Depth
Access: [Meas] > "Measurement Mode" > "AM Modulation Depth"
Adjust Setting..............................................................................................................366
Threshold.................................................................................................................... 366
Marker <x>..................................................................................................................366
Adjust Setting
See "Optimizing the measurement settings" on page 80.
Remote command:
not supported
Threshold
See "Defining a threshold" on page 80.
Remote command:
not supported
Marker <x>
See "Moving the markers" on page 80.
For manual marker control, also see Chapter 14.9.1, "Marker Positioning",
on page 120.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:MDEPth:RESult? on page 244
20.4.9 Measurement Menu: Occupied Bandwidth
Access: [Meas] > "Measurement Mode" > "Occupied Bandwidth"
Standard......................................................................................................................366
Level Adjust.................................................................................................................366
Channel Bandwidth.....................................................................................................366
% Power Bandwidth....................................................................................................367
Standard
See "Selecting a standard" on page 83.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:POWer:PRESet on page 233
Level Adjust
See "Defining the reference level" on page 83.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:LEVel:ONCE on page 233
Channel Bandwidth
See "Defining the channel bandwidth" on page 82.
Function Reference: Spectrum Application