R&S FPC Series - Page 370

Function Reference
R&S
®
FPC
367User Manual 1178.4130.02 ─ 07
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:OBAN:BANDwidth on page 240
% Power Bandwidth
See "Defining the percentage of the occupied bandwidth" on page 82.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:OBAN:BANDwidth:PCT on page 240
20.4.10 Measurement Menu: Signal Source
Access: [Meas] > "Source"
Off................................................................................................................................367
CW.............................................................................................................................. 367
Coupled CW................................................................................................................367
Tracking Generator..................................................................................................... 367
Level............................................................................................................................367
Normalize S21.............................................................................................................367
Normalization S21.......................................................................................................368
Off
See "Selecting the output frequency" on page 52.
Remote command:
SOURce:TG[:STATe] on page 228
CW
See "Selecting the output frequency" on page 52.
Remote command:
SOURce:TG:FREQuency on page 226
Coupled CW
See "Selecting the output frequency" on page 52.
Remote command:
SOURce:TG:FREQuency:AUTO on page 227
Tracking Generator
See "Selecting the output frequency" on page 52.
Remote command:
SOURce:TG:AUTO on page 226
Level
See "Defining the output level" on page 53.
Remote command:
SOURce:TG:POWer on page 227
Normalize S21
See "Calibrating a measurement" on page 56.
Function Reference: Spectrum Application