R&S FPC Series - Page 400

Function Reference
R&S
®
FPC
397User Manual 1178.4130.02 ─ 07
Phase
See "Unwrapping the phase" on page 176 and "Displaying the electrical length of the
DUT" on page 176.
Remote command:
Phase unwrapping: DISPlay<n>:PHASe:UNWRap on page 333
Calibrate
See Chapter 12, "Calibration", on page 54.
Remote command:
Start calibration: CALibration<n>:STARt? on page 230
Continue: CALibration<n>:CONTinue? on page 229
Abort calibration: CALibration<n>:ABORt on page 228
Query state: CALibration<n>:STATus? on page 231
Query type: CALibration<n>:MODE? on page 229
DTF Config
See Chapter 18.1.6, "DTF Configuration", on page 177
(Distance to fault measurements only.)
Select Cable Model ← DTF Config
See "Selecting a predefined cable model" on page 177.
Remote command:
CALCulate<n>:DTF:CABLe:PRESet on page 325
Clear Cable Model ← DTF Config
See "Selecting a predefined cable model" on page 177.
Remote command:
CALCulate<n>:DTF:CABLe:PRESet on page 325
Define User Model ← DTF Config
See "Creating a custom cable model" on page 178.
Remote command:
not supported
DTF List ← DTF Config
See "Displaying the DTF list" on page 174.
Remote command:
CALCulate<n>:TRANsform:DTFault:PEAK[:STATe] on page 327
DTF List Threshold ← DTF Config
See "Displaying the DTF list" on page 174.
Remote command:
CALCulate<n>:TRANsform:DTFault:PEAK:THReshold on page 328
Function Reference: Vector Network Analyzer