R&S FPC Series - Page 401

Function Reference
R&S
®
FPC
398User Manual 1178.4130.02 ─ 07
20.8.2 Frequency Menu
Access: [Freq]
Start Distance..............................................................................................................398
Stop Distance..............................................................................................................398
Center Frequency....................................................................................................... 398
Start Frequency...........................................................................................................398
Stop Frequency...........................................................................................................398
Signal Standard...........................................................................................................398
Start Distance
See "Defining the cable length" on page 179.
(Distance to fault measurements only.)
Remote command:
CALCulate<n>:DTF:DISTance:STARt on page 326
Stop Distance
See "Defining the cable length" on page 179.
(DTF measurements only.)
Remote command:
CALCulate<n>:DTF:DISTance:STOP on page 326
Center Frequency
See "Defining a center frequency" on page 94.
Remote command:
[SENSe:]FREQuency:CENTer on page 248
Start Frequency
See "Defining a start and stop frequency" on page 97.
Remote command:
[SENSe:]FREQuency:STARt on page 251
Stop Frequency
See "Defining a start and stop frequency" on page 97.
Remote command:
[SENSe:]FREQuency:STOP on page 251
Signal Standard
See "Working with channel tables" on page 97.
(Not for distance to fault measurements.)
Remote command:
Input mode: [SENSe:]FREQuency:INPut:MODE on page 249
Channel table (DL): [SENSe:]CHANnel:TABLe:SELect:DOWNlink on page 246
Channel table (UL): [SENSe:]CHANnel:TABLe:SELect:UPLink on page 246
Function Reference: Vector Network Analyzer