4000-SERIES INSTALLATION, OPERATION AND SERVICE MANUAL
144 of 154
C. General Inspection- Burner Inspection
__ No obstructions to the burner.
__ Spark igniter is secured and tight.
__ UV scanner is secured and finger tight.
Comments ___________________________________________________________________________
D. General Inspection- Temperature Control Operation
__ For conventional controls, temperature sensor wiring is shielded cable or standard wiring in a separate
circuit.
__ For Intelligent Controls, sensor and network cables are provided and terminated per cabling
specifications.
Cable Type ___________________________________________________________________________
E. General Inspection- Miscellaneous Items (Visually inspect air handler and note any relevant
observations.)
__ Unit properly weather-sealed.
__ All hardware is tight and secure.
__ All damper linkage is tight.
__ Filters are installed properly. (Aluminum mesh w/arrow in the direction of the airflow. Polyester w/the
white side upstream.)
__ For an indoor unit, pressure sensor "low" tap is run outdoors.
__ For an outdoor unit, pressure sensor "high" tap is run indoors.
Visible Damage _______________________________________________________________________
Comments ___________________________________________________________________________
F. Operational Checks- General Information
CFM ________________________________________________________________________________
Design ESP __________________________________________________________________________
Motor HP ____________________________________________________________________________
Motor FLA ___________________________________________________________________________
Comments ___________________________________________________________________________
To Next Page
Loading...
