SECTION 14: DISCHARGE ACCESSORIES
57 of 154
SECTION 14: DISCHARGE ACCESSORIES
14.1 One-Way, Three-Way and Four-Way Discharge Head Installation
All discharge heads are shipped assembled. The discharge head is designed for mounting to the face of the
air handler (covering the supply air opening) or to an interior wall. All discharge heads must be field
supported (by others). The discharge head has four outward-turned flanges. If the discharge head is to be
installed to the face of the air handler, install hardware (provided by others) on all four sides of the discharge
head.
Discharge heads can be installed on horizontal or vertical air handlers. To install the discharge head on an
interior wall, drill holes in the flanges on all four sides of the discharge heads to accommodate lag bolts
(supplied by others). Sheet metal (supplied by others) may be required.
Consult factory for detailed installation instructions based on unit orientation and discharge location.
Crush Hazard
Use proper lifting
equipment and
practices.
Falling Hazard
Use proper safety
equipment and prac-
tices to avoid falling.
Severe Injury Hazard
Use proper lifting
practices and equip-
ment.
Equipment and
accessories are
heavy.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and
service.
Edges are sharp.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
To Next Page
Loading...