5
Manual No. 016-3001-015 Rev. C 97
Using the OmniSeed Viper Pro System
8. Touch Next. If Product Application was selected, the Product Selection screen displays.
CAN nodes are controlled in a sequential manner and each single product node provides one product
control channel. The operator may only enable the number of control channels currently available on the
machine when setting up a new job. It is recommended to select the maximum number of product control
channels available on the machine each time a new job is started to allow the most flexibility during product
application.
For Example:
If product will be applied from a single tank, but the tank contains a mixture of three products, the operator
must enable one control channel to control rate for the mixture.
To only apply products associated with control nodes 4 and 5, the operator must select 5 on the Product
Selection screen during job setup. If only product nodes 1 and 2 in a 5 product CANbus system will be used
during a job, it is still recommended to select 5 products to allow the operator to enable or disable remaining
product nodes during the job as necessary without beginning a new job. This also allows the job to be re-
opened at a later date to apply additional products using other product nodes.
9. Enter the number of products which will be applied during the job application.
Product Setup
1. Touch Next. The Product #1 Setup screen displays.
2. Using the screen keyboard, enter a product name in the Product Name field.
3. To apply a prescription map to the job, enable the VRC option.
To Next Page
Loading...
