5
Manual No. 016-3001-015 Rev. C 117
Using the OmniSeed Viper Pro System
Alarms
If the Viper Pro is configured as the CANbus controller, the field computer will display a specific warning
prompt for any configured alarm conditions encountered. Any new warning conditions encountered by the field
computer will be displayed automatically when the condition is detected and will contain information to assist
the machine operator with addressing the alarm condition.
Touch the Display Data icon to access an overview of the tally register or current active alarm information for
each product node or control channel directly from the main screen.
In addition to the warning boxes, the Product Control area on the main screen will display a yellow ‘warning’
indicator instead of the green ‘thumbs up’ symbol and a Current Alarms button will be displayed at the bottom
of the CAN Controller Status screen if an alarm condition is active.
Note: Off rate and low limit alarms will automatically clear once the condition has corrected itself. All
other alarms will need to be cleared by touching the OK button on the warning prompt.
Addressing Alarm Conditions
To view any current alarms detected on the CANbus system from the Viper Pro main screen:
1. Touch the Product Control area at the bottom of the screen.
2. Select the Current Alarms button at the bottom of the CAN Controller Status screen. The Current CAN
Node Alarms screen displays:
To Next Page
Loading...
