Chapter 5
102 OmniSeed™ Viper Pro™ Installation & Operation Manual
Pausing and Resuming Jobs
While a job is in progress, the Viper Pro is continuously logging GPS location and other equipment status
information. This may not be desired at all times during an operation such as refilling tanks or bins or if the
machine will not be moving for a brief period. To help reduce the file size of completed jobs and to help
minimize the time required to perform file maintenance, jobs may be paused to keep the Viper Pro from logging
data not necessary for the job report.
Pause a Job
To pause an active job, touch Menu, then select Pause Job. The field computer will stop logging information
for the job report and “Job Paused” will begin flashing at the top of the Viper Pro display.
Note: The Viper Pro will continue to display the current vehicle position, but GPS location data will not be
logged.
If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Close Job button is selected. Refer to the Wireless File
Transfer section on page 217 for more information.
Resume a Paused Job
To resume logging data for the job report, touch Menu, then select Cont Job. The field computer will resume
logging of GPS and application data for the job report.
Note: If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Close Job button is selected. Refer to the Wireless File
Transfer section on page 217 for more information.
Application Rates Area
Use the Application Rates area to quickly check the status of each configured product node or control channel
during product application.
Note: The “Application Rates” heading will be hidden if multiple product nodes or control channels are
enabled to allow all information to be displayed on the main screen.
The Application Rate area displays the target rate (R
T
) and actual rate (R
A
) and the bin or tank level for each
product currently detected on the CANbus.
Note: Only products detected on the CANbus will appear in the Application Rates area.
To Next Page
Loading...
