8
Manual No. 016-3001-015 Rev. C 189
OmniSeed Section Control
Automatic Section Control Override Sec
The automatic section control Override feature allows the operator to momentarily apply product to a
previously applied area while in a job. The override feature is useful to ensure product application in small
unapplied areas near irregular headlands and previously applied areas. Enter the number of seconds to
override automatic section control and apply product after the master switch is toggled to the ‘OVERRIDE’
position.
Note: The time set as the override seconds does not start until the master switch returns to the on
position. Hold the master switch in the override position to sustain the override countdown if
desired.
Turn-Off % Coverage
This value controls the percentage of the section width that must be inside a previously applied area in order
for the section to turn off. The default value is 80%. This would require that 80% of a section be in a previously
applied area before the OmniSeed system would turn off that section.
Note: If the value is set to 0%, the section will not turn off automatically.
Configuring Automatic Section Control
1. Touch the Section Status area in the main Viper screen. The Section Control Setup screen displays.
2. Using the screen keyboard, enter a value, in seconds, in the ‘Turn-On’ Look-Ahead field.
3. Using the screen keyboard, enter a value, in seconds, in the ‘Turn-Off’ Look-Ahead field.
4. Using the screen keyboard, enter a value, in percentage, in the ‘Turn-Off’% Coverage field.
5. Using the screen keyboard, enter a value, if desired, in seconds, in the Section Control Override Sec
field.
To Next Page
Loading...
Need help?
General
