3
Manual No. 016-3001-015 Rev. C 23
Installation, Start Up, and Registration
2. When prompted, release the point. The next calibration point will be displayed.
3. Touch and hold the center of each remaining calibration point as they are displayed.
4. Once all points have been calibrated, touch in various areas of the screen to verify that the arrow appears in
the correct location.
Note: This screen will only be displayed for 1 minute. A count down of time remaining is displayed on the
Cancel button. If the calibration is not accepted before 1 minute lapses, the calibration will be
discarded and Viper Pro will continue to start up with the previous touch screen calibration.
5. Touch the Accept button to apply the recalibration and continue the Viper Pro start up sequence. Touching
the Cancel button discards the recalibration and the Viper Pro will start up with the previous touch screen
calibration.
Registering the Viper Pro
The Viper Pro must be registered if an optional feature activation key such as the multi-product VRA, AgX
prepopulated jobs, or a weather station will be activated. Activation keys are specific to each Viper Pro. Once
activated, a purchased key may not be transferred to another field computer.
Viper Pro Features
The following feature activation keys are available for the Viper Pro system:
• Air Seeder (P/N 077-0180-070)
• Multi-Product VRA (P/N 077-0171-152)
• Weather Module (P/N 077-0180-030)
• AgX Prepopulated Jobs (P/N 077-0180-059)
Air Seeder
The Air Seeder activation key allows the Viper Pro field computer to interface and control an air cart and seed
drill on an air seeder system. This feature allows the Viper Pro to automatically control seed rates for seed
products as well as liquid rate control sections during seeding operations.
Note: The Air Seeder activation key is required to control systems using the Gran 4 control mode which
is required for interfacing with the Raven OmniSeed system.
To Next Page
Loading...
