Chapter 6
126 OmniSeed™ Viper Pro™ Installation & Operation Manual
Swath Guidance Patterns
If ‘Swath Guidance’ is enabled during the start job process, the operator must select a swath pattern to use
during the job.
The following swath patterns are available.
Setting the Straight (A-B) Line Pattern
If Swath Guidance is enabled, the Viper Pro will automatically display the ‘Guide’ tab when a job is opened.
To begin swath guidance with the straight (A-B) line pattern:
1. Touch the Set A button to set the first point on the path at the current vehicle location.
Pattern Description
Straight A-B A straight A-B line pattern for parallel guidance.
Pivot A 360 degree (or circle) pattern.
Last Pass Guidance based on the last nearest pass driven.
Fixed Contour
Allows the operator to set an irregular A-B Line for
swath guidance.
To Next Page
Loading...
