Raven OmniSeed Viper Pro - USB File Transfer and Advanced File Maintenance

10
Manual No. 016-3001-015 Rev. C 207
Seed Blockage Sensors
2. Touch the Number Sensors field and use the on-screen keypad to enter the number of sensors in loop 1
for each configured section of the drill.
Note: Only enter values for the number of configured sections on the drill. Leave the value at zero for
any unused sections.
3. Touch the Next button and repeat the above process to configure sensor loop 2 if applicable.
4. Touch the OK button to complete the section calibration and save the entered settings.
Seed Monitor Setup
Each seed sensor loop may be configured individually to allow the OmniSeed system to accurately monitor the
status of separate delivery systems (e.g. seed or product tubes) and alert the operator to obstructions in either
delivery system.
To setup the seed monitoring system:
1. Touch the seed blockage sensor status area on the main screen.
The Seed Monitor Setup screen will be displayed.
2. The Seed Monitor Setup screen displays the following information for sensors in Loop 1 and Loop 2.
Enable Sensor Loops. Touch the radio button in front of the sensitivity field to enable sensor loops
Enable Sensor
Loop 1
Enable Sensor
Loop 2
Loop 1 Sensor
Count
Loop 1 Status
Loop 2 Status
Loop 2 Sensor
Count
Loop 1 Dirty or
Blocked Sensors
Loop 2 Dirty or
Blocked Sensors
Enable Audible
Alarm Feature