2
Manual No. 016-3001-015 Rev. C 7
Introduction
Front Panel
The front panel of the Viper Pro provides easy access to the power button and the USB connection. The
following is a description of the front panel features of the Viper Pro:
FIGURE 2. Viper Pro Front Panel
Press the power button to start up the Viper Pro field computer. The field computer takes approximately two
minutes to power up.
A USB port is conveniently located on the front of the Viper Pro field computer. Insert a USB flash drive into
this port to transfer compatible Viper Pro files.
Note: The USB flash drive must be formatted with the Viper Pro file structure. See Chapter 11, File
Maintenance and Editing Reports, for setting up the required file structure on a USB flash drive.
NOTICE
Failure to close a job before turning the field
computer power off may result in a loss of
information for that job. Make sure to properly
close any open jobs before shutting down the
computer.
CAUTION
Damage to the field computer may occur if the
USB ports are used to charge mobile devices
such as cellular phones, tablets, or mp3
devices. The USB ports should only be used for
performing file transfer and maintenance.
Power
USB Port
Touch Screen
To Next Page
Loading...
