Manual No. 016-3001-015 Rev. C 185
Advanced Settings and Features
7
Light Bar Guidance
Light bar guidance features of the Viper Pro may be used to display guidance information on the Viper Pro
touch screen or to send guidance information to an external Raven light bar connected to the auxiliary comm
port connector on the auxiliary interface cable. The Light Bar Setup screen offers the ability to quickly configure
the Viper Pro for either, or both, of these light bar guidance options.
The Viper Pro may also forward guidance information to an optional Raven SmarTrax automated steering
system connected to the guidance system.
Note: To use the light bar features of the field computer, a receiver capable of sending DGPS messages
at a minimum of 5 Hz must be connected to the Viper Pro.
1. To configure the light bar guidance features from the Viper Pro, touch Menu, then Setup, Lightbar. The
Light Bar Setup screen displays.
2. Enable the desired light bar options:
On-Screen Lightbar. Enable this option to display a light bar at the top of the Viper Pro touch screen while
guidance is enabled during an active job. The on-screen light bar will be displayed regardless of which tab is
active during the job.
External Lightbar. Enable this option to allow the Viper Pro to display guidance information on an external
Raven light bar.
Send Guidance Message. Enable this option to send guidance messages from the Viper Pro to an optional
Raven SmarTrax automated steering system.
To Next Page
Loading...
