Chapter 3
20 OmniSeed™ Viper Pro™ Installation & Operation Manual
Start Up
Note: Before connecting or using any additional or optional components with the Viper Pro precision
application management system, be sure to follow any installation instructions and verify proper
installation.
Before powering up the Viper Pro, check that the field computer is properly mounted and all power
and cable connections have been installed properly as instructed in the previous sections.
Once installation of the Viper Pro precision application management system has been completed and verified,
the field computer may be powered up.
To start up the Viper Pro:
1. Press the power button on the Viper Pro. The field computer will take approximately 2 minutes to power up.
Note: Pressing the power button when the following prompt is displayed on-screen will launch the touch
screen calibration wizard without displaying the Program Selection Menu.
This prompt is displayed for approximately five seconds and may be ignored to display the
Program Selection Menu as normal.
To Next Page
Loading...
