Manual No. 016-3001-015 Rev. C 179
Advanced Settings and Features
7
Local Settings
The Local settings allow the operator to set up preferences for:
• Language
• Profile Configuration
• Units Configuration
• Time Zone Configuration
Refer to the Initial Set Up section on page 37 for detailed information on setting up these settings and saving a
machine profile. Refer to the following section for more information on the automatic power down feature.
Power Option
The automatic power down feature allows the Viper Pro to automatically close any active job file and power
down the console when the vehicle ignition is switched off. This feature may be enabled to help ensure that job
information is saved and the field computer is properly powered down.
Note: The default setting for the power down feature is enabled. To monitor the vehicle ignition status,
the field computer will require the appropriate wiring harness and a connection to the vehicle
ignition. Without the appropriate harness, the power down feature will have no affect on operation
of the Viper Pro field computer.
1. Touch Menu, Setup, Local and Power Option to display the Automatic Power Down screen.
Select the ‘Enable automatic power down’ option to allow the field computer to shutdown when the ignition
is switched off.
Disable this feature to keep the field computer powered on until the operator powers down the console
manually. Review the Powering Down the Viper Pro section on page 72 for proper shut down procedures.
2. If enabled when the ignition is switched off, the field computer will display an alert to the operator and allow
the operator to cancel the automatic power down. Cancel the power down to keep the field computer
powered on after the ignition is switched off.
To Next Page
Loading...
