Chapter 6
130 OmniSeed™ Viper Pro™ Installation & Operation Manual
Setting the Pivot Pattern
If Swath Guidance is enabled, the Viper Pro will automatically display the ‘Guide’ tab when a job is opened. To
begin swath guidance with the pivot pattern:
1. Start with the machine located at a point on the outside of the center pivot area and touch the ‘Set A’ button
on the screen.
2. Drive along the outside of the pivot pattern area and touch the ‘Set B’ button on the screen. Viper will create
a circular guidance path using the ‘A’ and ‘B’ points selected and display guidance paths toward the inside
of the circle.
Note: Currently, this pattern does not require that a complete pivot pass be driven to create a guidance
path, however, the best results are usually obtained by driving further along the initial pivot swath
before setting the ‘B’ point.
To Next Page
Loading...
