Chapter 7
186 OmniSeed™ Viper Pro™ Installation & Operation Manual
Configuring the Light Bar Display
When the on-screen or external light bar options are enabled, the Viper Pro field computer may be used to
configure the light bar display. These settings can help the operator set the accuracy of the light bar for
different operations or display preferences.
1. To configure the light bar guidance features from the Viper Pro, touch Menu, then Setup, and Lightbar.
2. Touch the Next button. Review the on-screen description of the LED values and enter the desired distances
from the swath required to illuminate the light bar.
3. Standard light bar operation will illuminate the light bar in the direction of the guidance path from the current
vehicle position. In this mode, the operator will need to steer toward the lights to get back onto the guidance
path. To reverse the light bar display, select the Reverse LEDs option. This mode will require the operator
to steer away from the illuminated lights. Select the option that best suited for the operator.
Section Setup Wizard
The applicator boom or implement section configuration is required to set up the Viper Pro system to monitor or
control product application. Refer to the Section Setup section on page 53 for a detailed description of the
boom or implement setup procedure.
To Next Page
Loading...
