Chapter 4
72 OmniSeed™ Viper Pro™ Installation & Operation Manual
Profile Changes
If any of the settings saved within a profile are changed during operation of the field computer, the Viper Pro
will prompt the operator to save the current profile settings before the field computer is powered down.
To save the current set up in a new profile, type in a new profile name and touch OK.
Note: Enable the ‘Use this profile on next Viper startup’ option to load and use the new profile the next
time the field computer is powered on.
Powering Down the Viper Pro
It is always recommended to shutdown the Viper Pro prior to removing power from the field computer. To
properly power down the field computer:
1. Touch the Menu button in the lower, right corner of the display.
2. Select the Exit button. The Exit Viper prompt will display on the field computer.
To Next Page
Loading...
