Chapter 7
140 OmniSeed™ Viper Pro™ Installation & Operation Manual
Section Assignments
When connected to the OmniSeed system, the Section Select screen is required to complete the initial
calibration of the implement or drill. Refer to the Section Selection section on page 68 for details on assigning
products to sections on the OmniSeed system.
Fan and Pressure Cal
The Fan RPM area displays the current RPM of the air cart fans. Touch within the Fan RPM area to display the
Fan Calibration screen and calibrate the fans.
Note: Refer to the Optional Bin Pressure Sensor section on page 44 or the Fan Cal section on page 52
for more information on configuring the bin pressure or fan speed calibrations.
Miscellaneous Settings Area
The information displayed in the Miscellaneous area is an overview of the settings and current system status.
The Miscellaneous area displays an overview of several current system settings for the system.
Note: Touching within the Miscellaneous area will display the Miscellaneous Settings screen.
To Next Page
Loading...
