3
Manual No. 016-3001-015 Rev. C 15
Installation, Start Up, and Registration
3. Use the eight flat head screws to fasten the mounting bracket to the Viper Pro field computer.
4. Match up the two mounting posts on the back of the switch box with the smaller flange of the mounting
bracket.
5. Use two phillips head screws to mount the switch box to the mounting bracket.
6. The remaining clamps and four hex bolts will be used to secure the Viper Pro field computer and switch box
to the selected mounting post within the vehicle cab.
Mounting the Viper Pro and Switch Box in the Cab
1. Select a location to mount the Viper Pro field computer. Refer to the following requirements when selecting
a mounting location for the Viper Pro field computer:
• The Viper Pro is not weatherproof. Mount the field computer inside of the machine cabin or
drivers compartment within easy reach of the driver or operator.
• Secure the field computer to an existing post or display bar using the provided bracket.
• If necessary, securely fasten the mounting bracket (P/N 107-0171-415) to a suitable, flat
surface. Once mounted, the bracket must provide a stable base for the field computer and
should not impede normal machine operation.
• The Viper Pro should be mounted in a location where it will not be jarred during normal
equipment operation. Keep the field computer clear of moving elements within the machine’s
cab.
• Keep cable routing in mind when selecting a mounting location to avoid tripping hazards or
damage to the cable during normal operation.
2. Use the remaining clamps and four hex bolts to secure the Viper Pro and switch box to the selected
mounting post within the vehicle cab.
Mounting
Posts
CANbus
Connector
Logic Power
Connector
Speed
Connector
To Next Page
Loading...
