Chapter 3
22 OmniSeed™ Viper Pro™ Installation & Operation Manual
4. If the Viper Pro is set as the CAN Controller, the Viper Pro will attempt to establish communication with the
CANbus system. The CAN Initialization Results screen displays the results of CANbus detection.
5. If the status of the CAN nodes is displayed properly, touch the Start Viper button to finish the start up
sequence.
Note: Refer to Chapter 4, Initial Set Up and Navigation, for more information on the CAN Initialization
Results screen, or information on setting up or troubleshooting the CANbus or CAN nodes.
If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Start Viper button is selected and the Main screen is
displayed. Refer to the Wireless File Transfer section on page 217 for more information.
6. The Viper Pro main screen will display. For a description of the features and information displayed on the
main screen, see Chapter 4, Initial Set Up and Navigation.
Touch Screen Calibration Wizard
When the operator touches an area of the screen, the Viper Pro displays an arrow in the area where the
selection has been made. If this arrow does not appear in the correct location, the touch screen may require
recalibration.
There are two ways to access the Touch Screen Calibration Wizard:
• Press the power button while the start up prompt is displayed.
• Select the Calibrate Screen option at the bottom of the Program Selection Menu screen.
To complete the Touch Screen Calibration Wizard:
1. Touch and hold in the center of the first of four calibration points.
To Next Page
Loading...
