3
Manual No. 016-3001-015 Rev. C 21
Installation, Start Up, and Registration
2. The Program Selection Menu will display if the Viper Pro was powered off at this screen the last time the
field computer was on.
Note: To skip the Program Selection Menu next time the Viper Pro is powered up, shutdown the field
computer from the Viper Pro application. Within the Viper Pro application, touch the Menu button
in the lower, right corner of the screen and select Exit, Shutdown Viper.
Pressing and holding the Power button to shutdown the Viper Pro is not recommended. This
procedure should only be used in situations when normal shutdown is not possible.
Select the:
• Sprayer/Spreader to launch the Viper Pro precision application management system in a liquid
or granular applicator mode. Refer to the Raven Viper Pro Installation and Operation Manual for
more information on operation of the field computer in this mode.
• OmniSeed to launch the Viper Pro precision application management system in an air seeder
mode.
• Brightness Control option to adjust the screen brightness.
• Front Panel option to configure Raven DGPS Receivers directly with the Viper Pro using the
Front Panel Program. See Appendix E, Using the Front Panel Program with the Viper Pro
System, for detailed instructions on setting up and using the Front Panel Program.
• XP Desktop option to view the Windows
®
desktop on the Viper Pro field computer.
• Install Viper Pro option to install the Viper Pro application. This option is only displayed if a flash
drive containing the Viper Pro startup directory is inserted into the Viper Pro.
• Update CAN Nodes option to begin the CAN update program. Refer to Appendix D, Updating
CAN Nodes via the Viper Pro, for more information.
• Calibrate Screen button at the bottom of the screen to begin the touch screen calibration
wizard.
3. Select the OmniSeed option to launch the Viper Pro precision application management system.
To Next Page
Loading...
