Chapter 4
42 OmniSeed™ Viper Pro™ Installation & Operation Manual
Rate Cal(s)
1. Touch within the Product Control area at the bottom of the main screen.
2. Make sure that Node 1 is selected on the CAN Controller Status screen and touch within the second data
display, or Product Control Settings area, on the CAN Controller Status screen.Touch the Rate Cal value
displayed on the screen and use the on-screen keypad to enter the desired target rate for a product
application.
Note: During the initial set up of the field computer, enter a typical rate for seeding operations. The rate
cal will need to be adjusted for different seeding operations on each product control channel prior
to starting an actual seeding operation. Contact a local planter or seed supply dealer for
assistance.
3. Repeat the above process for any remaining product nodes or control channels as necessary.
4. Touch OK to save the entered value or proceed to the Bin Level Sensor Calibration section to continue with
the initial set up process.
To Next Page
Loading...
