4
Manual No. 016-3001-015 Rev. C 41
Initial Set Up and Navigation
5. Select one of the following application types for the selected product channel or control node:
Liquid. Application of liquid products.
Gran (Granular) 1. Dry or granular product application using a single encoder to meter application equipment
with a single bed.
Gran (Granular) 2. Dry or granular product application using a single encoder to meter application from
equipment with a dual bed.
Gran (Granular) 3. Dry or granular product application using a dual encoder configuration to meter application
from equipment with a dual bed.
Gran (Granular) 4. An air seeder system on which a seed gate or segmented meter roller is used to control
seed for active sections before the seed has entered the air system. Most air seeder control systems will be
controlled using this application type selection.
Gran (Granular) 5. An air seeder system on which a manifold or distribution bin is used to control air flow to
active sections after the seed has entered the air system. This application type will control the RPM of the
meter roller based upon active drill sections.
Note: An optional OmniSeed authorization key is required for Gran 4 and Gran 5 application types to
enable the field computer to control air seeder control systems. Contact a local Raven dealer for
purchasing information and refer to the Activation Key Request section on page 24 to enter the
activation code to unlock the Gran 4 and Gran 5 application type selections.
Spinner. Select this option for RPM control of spinner speed during field operations.
NH3. An option for anhydrous ammonia rate control operations will be available if the product node is capable
of specific rate control features. It is recommended to ensure this option is available and selected when
controlling the application of anhydrous ammonia during field operations.
NH3 Boost. The anhydrous pump control selection will be available if the product node is capable of specific
control features for the AccuFlow HP boost pump. Select this option to allow the operator configure specific
boost pump control features for field operations.
Any product channel used to control products from the air cart must be set to Gran 4 or Gran 5.
Note: Control channels for liquid or anhydrous ammonia products may be set for Liquid, Gran 1 (single
bed, single encoder), Gran 2 (dual bed, single encoder) or Gran 3 (dual bed, dual encoder).
Depending upon the product node connected to the system, options for spinner or injection control
may also be available. If the control system detects an injection node, the application types will be
limited to liquid injection or granular injection. Refer to the Raven Viper Pro Installation and
Operation Manual for more information about spinner control operations.
6. Repeat the above process for remaining product nodes or control channels as necessary.
7. Touch OK to save the currently displayed settings and return to the CAN Controller Status screen.
To Next Page
Loading...
