Chapter 4
74 OmniSeed™ Viper Pro™ Installation & Operation Manual
Navigating the Viper Pro Interface
The following sections provide an overview to navigation of the Viper Pro user interface and may be used to
familiarize operators to various information displays on the Viper Pro touchscreen and for help navigating
through settings screens and menus. Detailed information about the individual settings may be found in
Chapter 7, Advanced Settings and Features.
Main and Job Screen Displays
The following information can be found on the Viper Pro screen:
Active Profile and Product Selection
The active profile is displayed above the map area on the Main tab. Before starting a job, be sure that the
correct profile is selected.
During an active job, the map area displays coverage or as-applied information based upon the product node
or control channel selected in this area.
Note: The Viper Pro may also display an on-screen light bar at the top of the screen during an active job.
Refer to the Light Bar Guidance section on page 185 to enable the on-screen light bar feature.
1. Active Profile or
Product Selection
2. Section Status 3. Vehicle Heading
and Speed
4. Fan RPM and
Pressure
5. Map Area 6. Tabs 7. Map Tools 8. Display Data
9. Wireless
Communication
Status
10. Product Rates
Area
11. Product Control
Status Display
12. SmarTrax Status
Indicator (if
present)
13. GPS Status
Display
14. Packing Pressure 15. Seed Blockage
Sensor Status
(optional)
16. Menu
1
7
8
11
12
6
3
4
9
13
2
16
5
10
11
1514
To Next Page
Loading...
