4
Manual No. 016-3001-015 Rev. C 75
Initial Set Up and Navigation
Section Status Indicators
The Section Status area displays the configured sections and their current status.
Note: For more information on configuring the sections and vehicle, see Section Setup section on
page 53. Touch within the Section status area to configure the section control settings.
The status indicators display the current status of each section on the seed drill during an active job.
Section Off. If the section switch is toggled off, the status indicators will display a white background. This
indicates that the section is toggled off and that the OmniSeed system will not automatically turn on the product
section when the implement or drill moves into an uncovered area.
Section On. A green section display indicates that the section switch is either in the on position or in the
ACCU position for automatic section control and that the section is currently controlled on.
Note: OmniSeed automatic section control will not automatically control rollers or augers unless the
section switch is in the ACCU position.
Section Enabled/Not Active. If the section switch is in the ACCU position and the section is currently
controlled off.
Vehicle Heading and Speed
The Viper Pro displays the current GPS course over ground, in compass degrees, and the reported speed from
a ground speed sensor or GPS receiver.
Note: A heading of 000° indicates magnetic north.
The Viper Pro speed display indicates both the detected vehicle speed as well as the source and use of the
displayed speed.
• If ‘CAN’ is displayed in the speed area, the Viper Pro is registering speed from the Raven CANbus control
system. The Viper Pro is also using the displayed speed value for speed compensated product rate control.
• If ‘GPS’ is displayed in the speed area, the Viper Pro is monitoring speed from a GPS receiver (e.g. an
Invicta or Phoenix series receiver). ‘GPS’ will be displayed when the Viper Pro is connected to an optional
Raven serial control console. In this instance, the speed displayed on the Viper Pro is for reference only
and is not used to adjust product rate. Verify that the speed reading on the serial controller is accurate.
Review the Speed Sensor Type and Cal section on page 38 if the speed reported by the Viper Pro does not
approximate the actual vehicle speed.
Switches Off
Switches On
Switches On
(Section Enabled/
Not Active)
To Next Page
Loading...
