Chapter 10
206 OmniSeed™ Viper Pro™ Installation & Operation Manual
Seed Blockage Node Detection
If the seed blockage system is installed and correctly connected to the Viper Pro, the seed blockage node
should display on the CAN Initialization Results screen when the field computer is powered on.
If the seed blockage node is not displayed on this screen during start up, check the node connections and
touch the Retry CAN Init button before starting the Viper Pro application. If the node is still not detected,
contact a local Raven dealer for assistance.
Configuring Blockage Sensor Loops
To properly monitor the seed delivery system, the Viper Pro must be configured for the number of seed
blockage sensors installed in each section of the drill.
1. Review the Section Setup section on page 53 to configure the air seeder and drill and touch the Next button
on the Section Width Setup screen to display the Blockage Loop 1 Sensor Setup screen.
To Next Page
Loading...
