Chapter 7
156 OmniSeed™ Viper Pro™ Installation & Operation Manual
To modify product control settings for the above features, touch within the product control settings area on the
CAN Controller Status screen.
Note: The selected product control node appears with a check mark in the corresponding radio button at
the top of the Feature Settings Area. To switch the selected node, touch the radio button for the
desired product node.
Node Control Settings Screen (Page 1)
Touch within the Product Control Settings area to view the first screen of settings for the selected product node
or control channel.
Note: Touch the Next button to access additional product control settings for the selected product node
or control channel.
Tank Volume. Enter the initial volume of product in a tank or bin. As product is applied using the corresponding
node or control channel, the Viper Pro will calculate the volume remaining in the tank or bin and display the
value on the CAN Controller Status screen, the Tally Registers screen and in the Display Data prompt.
A tank volume is required when using the low tank alarm value. Refer to the Low Tank section on page 145 for
more information on the low tank alarm.
When refilling a tank or bin during an application, the tank volume may be quickly reset using the Tally
Registers screen. Refer to the Tally Registers section on page 114 for information on resetting the tank
volumes to a preset value.
Status Screen Example
(Liquid)
To Next Page
Loading...
