Chapter 7
182 OmniSeed™ Viper Pro™ Installation & Operation Manual
Raven GPS Setup
1. To automatically configure the GPS Comm Port Setup for a Raven DGPS receiver, touch Menu, then Setup
and Comm Ports. The GPS Comm Port Setup screen displays.
2. Select the Raven GPS preset to automatically configure the communication ports for the following
receivers:
Note: Make sure that the Raven receiver is properly connected and powered up before configuring it with
the Viper Pro system. Viper will automatically configure the GPS comm port to the following
settings:
• Baud = 19200
• Data Bits = 8 bits
• Stop Bit = 1
• Parity = None
3. Touch the View Data button to confirm that the Viper Pro is receiving GPS messages or touch OK to return
to the Viper Pro main screen.
Note: If the Viper Pro is unable to receive GPS messages from the Raven receiver, refer to Chapter 12,
Troubleshooting the Viper Pro System, or contact a local Raven dealer for assistance.
• RPR 100S • Invicta 310
• RPR 100G • Phoenix 50
• Invicta 110 • Phoenix 200
• Invicta 115 • Phoenix 250
• Invicta 210
To Next Page
Loading...
