4
Manual No. 016-3001-015 Rev. C 85
Initial Set Up and Navigation
• The Miscellaneous Settings Area displays an overview of current selections for the display units, speed
sensor and current vehicle speed, etc. Information about the CANbus nodes is also accessible by touching
within this area. Refer to the Miscellaneous Settings Area section on page 140 for more information.
• The Fan RPM displays the current fan speeds for fans 1 and 2 supplying air flow for the products in the air
cart bins. Refer to the Fan Cal section on page 52 for details on calibrating the air cart fans.
• Use the Node/Channel selection to view the current settings for a specific product node or control channel.
When modifying settings, be sure to select the appropriate product node or control channel before changing
any settings.
• The Feature Settings Area displays an overview of the currently programmed alarm settings and features
for the selected product node or control channel. Refer to the Feature Settings Area for Granular Products
section on page 144 or the Feature Settings Area for Liquid Products section on page 147 for more
information on available features accessible through the feature settings area.
• The Product Control Settings Area displays the current calibration and application settings for the
selected product node or control channel. Refer to the Product Control Settings Area for Granular Products
section on page 152 or the Product Control Settings Area for Liquid Products section on page 155 for more
information on the settings required for controlling rate of product application.
• The pressure registered by an optional transducer is displayed in the Pressures Area. Touch within the
pressures area to calibrate the pressure transducer. Refer to the Dual Pressure Area section on page 160
for more information.
• The Application Area displays the selected application type and control valve selection for the selected
product node or control channel. Refer to the Application and Control Valve Type(s) section on page 40 for
more information on the control valve and application type settings.
• Touch the Tally Registers button to view or reset application volume and area tallies for each node or
channel or the Viper Pro odometer.
Note: The tally registers information may also be displayed by selecting the ‘Display Data’ icon on the
main screen.
• A CAN Profile may be used to copy or back up the settings for nodes on the CANbus. Use a CAN profile to
quickly reset or restore settings for various seed types or products controlled with the Viper Pro field
computer.
• The Current Alarms button is displayed only when an alarm condition is detected by the Viper Pro during
an active job. Refer to the Alarms section on page 117 for detailed information on alarm conditions.
To Next Page
Loading...
