Ricoh CH-C1 - Page 176

Technical Bulletin PAGE: 3/4
Model: CH-C1a
Date: 17-Jan-14
No.: RD135060
4. Configuring the Remote Reception Settings
Do the following procedure to enable the Client-side Machine(s) to receive faxes via the
Remote Machine. You can forward or route received documents per line or special sender
or box.
NOTE:
By performing procedures #1-3 above, the Client-side Machines can send faxes via the
Remote Machine. The procedures shown below are necessary to enable the Client-side
Machines to receive faxes.
On the Remote Machine:
1) If you use "Remote Reception Setting per Line"
1. Press [Facsimile Features].
2. Press [Remote Reception Setting per Line] in [Reception Settings].
3. Enter an IP address or a host name of the client-side machine to connect.
4. Press [Set], and [Exit] to exit from the setting.
2) If you use "Remote Reception per Sender"
1. Press [Facsimile Features].
2. Press [Program Special Sender] in [Reception Settings].
3. Select the Special Sender.
4. Press [Remote Reception Setting per Sender].
5. Press [On] and [Remote Machine].