Technical Bulletin PAGE: 4/5
16. Input the following SP settings according to the notes you took in Step 5.
SP5-193-001 (External Controller Info. Setting)
SP5-895-001 (Application invalidation / Printer)
SP5-895-002 (Application invalidation / Scanner)
SP5-985-001 (Device Setting / On Board NIC)
SP5-985-002 (Device Setting / On Board USB)
The message "Completed. You have to reboot." will appear after inputting
each of the above SP settings, but ignore this message and press the “Exit”
button. DO NOT reboot at this moment.
17. Turn off the main power switch. This will take about 3 minutes. Wait until the machine
power is turned off completely, and then remove the SD card from slot #2.
18. Turn on the main power switch.
19. Insert the SD card containing the Address Book Data removed in Step 11 into slot #2.
20. Execute SP5-846-052 (UCS Setting / Restore All Addr Book) to download the Address
Book Data on to the new NVRAM.
NOTE: SP5-846-052 will fail if the settings in SP5-193-001, SP5-985-001 and SP5-
985-002 inputted in Step 16 are incorrect.
The message "Completed. You have to reboot." will appear if SP5-846-052
results in success.
21. Turn off the main power switch and remove the SD card from slot #2.
22. Turn on the main power switch.
Procedure for D135/D136 (Office model) only
Confirm that the “Reception Settings” and “Send Settings” correspond with the notes
you took in Step 9. Correct the settings if they are wrong.
23. Print out the SMC data (“ALL”) with SP5-990-001, and make sure that it matches the
SMC data printed out in Step 2 (except for the total counter value).
Note: The total counter value is reset to “0” when the NVRAM is replaced.
24. Do the self-check Process Control.
25. Do ACC for the copier application program.
26. Do ACC for the printer application program.
To Next Page
Loading...
