Technical Bulletin PAGE: 10/11
Reissued:27-Mar-14
Model: Finisher SR4090/Booklet Finisher SR4100
Auxiliary Trays
Make sure that the customer understands the following points about these auxiliary trays:
・ The trailing edges of excessively curled or Z-folded paper can activate the tray full
sensors before the tray is actually full.
・ Once the "Exit Tray Full" message displays, the job cannot continue until some sheets
are removed from the tray which is only partially full. The trays are designed to prevent
this problem.
Shift Auxiliary Tray
Install the shift auxiliary tray [A] ONLY when the “Multi-Folding Unit FD4000 (D615)” is
included in the configuration. Note that the Shift Auxiliary Tray [A] may generate
unexpected side effects, for example, paper jams caused by displaced paper height
detection feeler [B].
To Next Page
