Technical Bulletin PAGE: 4/11
Reissued:27-Mar-14
Model: CH-C1 Finisher SR4110
Installation Procedure
Turn the machine off and disconnect the machine power cord before you do this
procedure.
1. Unplug the machine power cord before starting the following procedure.
2. Unpack the finisher and remove all tapes and shipping retainers.
3. Open the front door and remove the shipping retainers.
4. Remove the brackets, tags, and wires in this order: [A]> [B]> [C] ( x 2 each).
5. Be sure to remove the two sheets of paper [D].
To Next Page
